Back to Skunk2 Main Page

Skunk2 Racing Composite Fuel Rail 2001-2007 Mitsubishi Lancer Evolution 7/8/9

---

Skunk2 Racing’s cutting-edge Composite Fuel Rail for the Evo VIII-IX is here. Skunk2’s Composite Fuel Rails are made using a proprietary carbon-impregnated, aerospace thermo-polymer composite—a material that’s 33-percent lighter, 60-percent stronger, and operates up to 100-degrees F cooler when compared to aluminum and insulates fuel from both radiant and conductive heat transfer underneath the hood, resulting in increased horsepower and torque. Composite Fuel Rails also feature large 0.625-inch internal bores for superior fuel injector pulsation dampening, are machined with a smooth interior finish, and feature radius-cut fuel injector outlets for improved flow characteristics. The special design that eliminates the sharp internal angles where the main bore meets the fuel injector bores inherent with conventional extruded- and drilled-aluminum designs can only be achieved with such composite materials. Skunk2’s Evo Composite Fuel Rails are compatible with the factory fuel system, as well as all fuels, including alcohol, and can support up to 1,200 hp.

PLEASE READ CAREFULLY BEFORE PROCEEDING WITH INSTALLATION
Product Disclaimer
· There is no warranty stated or implied due to the unusual stresses placed on competition products and/or the inability to monitor the modification, installation and use. The entire risk of quality, performance and defect is with the purchaser and not the manufacturer, distributor or retailer. Should any product(s) prove to be defective for any reason under any circumstance, the purchaser and not the manufacturer, distributor or retailer will assume financial responsibility for any consequential damages, repairs/service and any other liability.
· A vehicle modified by the use of competition product(s) for use on public roadways may not meet local, state or federal regulations. Installation and use of this competition product(s) may also affect vehicle insurance coverage. It is the purchaser’s responsibility to meet and comply with regulations and policies before operating the vehicle on public roadways.
· Return of product(s) will ONLY be accepted if product(s) is in resell able condition. All accepted returns will be subject to a 20% restocking fee. ABSOLUTELY NO RETURNS ON USED PRODUCTS. For more information on our return policy, please call (951) 808-9888.
· CUTTING OR MODIFYING THE PRODUCT WILL VOID THE WARRANTY!!!
· For technical support, visit the HelpDesk at www.skunk2.com or call (951) 808-9888

· Group A Autosports Inc., recommends the following performance products to maximize power gains:
o Header/high-flow exhaust system
o Cold-air intake system
o Fuel pressure regulator
o Camshafts/adjustable cam gears

Warranty Policy
Group A Autosports Inc. warranties all products to be free of defects in materials and workmanship for normal use and service for a period of 90 Days from the date of retail purchase. Products returned must be inspected and determined to be defective by Group A Autosports Inc. before any warranty credit and/or replacement is issued. Group A Autosports Inc.’s obligation under warranty shall be limited to repairing or replacing, at its discretion, any product found to be defective. The consumer will be responsible for transportation charges. Final determination of the suitability of the product(s) for the intended use is the sole responsibility of the consumer. Group A Autosports Inc. shall not be liable for any special, direct, indirect, incidental or consequential damages that may be claimed as a result of the failure of any product, including claims for delay, loss of profits or labor. Group A Autosports Inc. shall not be liable for any damage and/or injury to person(s) and/or property resulting from improper installation and/or misuse of any product subject to this warranty. There are no other warranties expressed and/or implied extending beyond those set forth above.